How do pneumatic component manufacturers easily troubleshoot pneumatic components?- Ningbo Hengmin Lingtong Pneumatics Components & Set Co., Ltd.

According to relevant data, the market trend of pneumatic components is developing towards safer and more reliable performance. We can know from the pneumatic standard that the standard puts forward the interchangeability requirements and also emphasizes the issue of safety performance. The pressure of the compression test of pipe joints and shells is increased to 4 times to 5 times of the working pressure. In such a high-standard environment, how should the operator easily troubleshoot the pneumatic components?

The failure of pneumatic components is mainly composed of many aspects. Let's take a look at it together!

Air leakage occurs at the end of the piston rod, air leakage occurs between the cylinder barrel and the cylinder head, and air leakage occurs at the buffer adjustment position. When air leakage occurs at these three positions, we should pay attention to whether the piston rod is installed eccentrically; lubricating oil There is insufficient supply; the piston seal is worn; there are impurities on the bearing mating surface of the piston rod; the piston rod has scars. When we found a problem after these conditions, it was reinstalled and adjusted so that the piston rod was not eccentric and laterally loaded. Check whether the lubricator fails, replace the sealing ring to clean and remove impurities, install and replace the dust cover, and replace the piston rod.

When there is an internal leakage problem in the pneumatic components, the air at both ends of the piston, the piston sealing ring is damaged, the lubrication is poor, the piston is stuck, the piston mating surface is defective, and impurities are squeezed into the sealing ring. Replace the seal, check whether the lubricator fails, reinstall and adjust it so that the piston rod is not affected by eccentricity and lateral load, remove impurities and use the purification system to compress the air.

When the cylinder head of the pneumatic component is damaged, the buffer mechanism will not play any role. At this time, we should set the buffer member in the external or circuit.

Push-in pneumatic pipe joints